Ubiquiti Enterprise Campus 24 PoE is a managed switch designed for use within the UniFi system. It is equipped with 16 × 10G Ethernet ports, 8 × 2.5G Ethernet ports, and 2 × SFP28 (25G) slots. All Ethernet ports support PoE+++ (802.3bt Type 4) output, with a maximum power output of 90 W per port. The total PoE power budget is 1050 W in Shared Mode, where both 600 W power supplies operate simultaneously. If you choose to run the switch in Redundant Mode (where one power supply acts as a backup), the available PoE output power is reduced to 450 W. Optional 1200 W power modules are also available, allowing a high PoE budget even in Redundant Mode. The Ethernet ports support the Etherlighting feature — when used with compatible patch cords, the ports can be illuminated (for example, to simplify identification). The switch supports selected Layer 3 management functions, including DHCP Server, DHCP Relay, Inter-VLAN Routing, and Static Routing. It also supports all standard Layer 2 functions, which are listed in the specifications below. The device is designed for installation in a 19" rack cabinet, and due to its weight, the manufacturer recommends mounting it on four rails.

UnFi Enterprise L3 switch

The offered product is a managed switch designed to operate under the UniFi system. It belongs to the Enterprise series, intended for use in large, advanced networks. It supports Layer 3 functions: DHCP server, DHCP Relay, Inter-VLAN routing, and static routing. In addition, it supports numerous standard Layer 2 functions — their full list can be found in the specifications below the description.

16x 10G Ethernet ports, 8x 2.5G Ethernet ports, 2x SFP28 slots

The switch is equipped with 16 10G Ethernet ports, 8 2.5G Ethernet ports, and 2 SFP28 (25G) slots, which translates into a total throughput of up to 230 Gb/s. It will perform perfectly in networks whose main infrastructure is based on 25G bandwidth, allowing you to connect modern access points equipped with 10G / 2.5G interfaces. Additionally, each Ethernet port supports automatic speed negotiation up to 10 Mb/s, which significantly facilitates the expansion and modernization of an existing network.

24 PoE+++ ports, power budget up to 1050 W

Each Ethernet port has a PoE+++ (802.3bt Type 4) power output. The output power of a given port depends on the standard used and is 15.4 W for PoE (802.3af), 30 W for PoE+ (802.3at), 60 W for PoE++ (802.3bt Type 3), or 90 W for PoE+++ (802.3bt Type 4). You can connect any UniFi access point or other devices, such as UniFi Access series hubs, to the switch. The set includes 2 power modules of 600 W; if operating in Shared mode (and both connected to a power source), the maximum PoE budget is 1050 W. Using Redundant mode (one of the power supplies acts as backup), the PoE power budget is 450 W. Optionally, you can purchase 1200 W power modules.

Redundancy

The device is designed for uninterrupted operation. It has 2 power supplies that can operate in Redundant mode – if one fails, the other takes over. The switch has 4 hot-swap fan modules, operating in a 3+1 redundant mode. All of the above modules can be purchased separately and replaced without shutting down the switch.

Application

ECS-24-PoE was designed to operate as an access switch in large networks where you use modern Wi-Fi 7 access points. It provides a very high power budget and, most importantly, reliable operation thanks to the use of hot-swap power and fan modules. High switching performance and Layer 3 management make it ideal for many networks.

Specifications